Portable 12 volt car jumper

【1】The car cannot be continuously ignited to start the car / or the key is not released, and the next start will be carried out after 30 seconds between each start
【2】The positive and negative poles cannot be reversed. Two clips cannot be connected short-circuited.
【3】Remove the clip within 30 seconds after successfully starting the car.
Violation of the above 3 points may cause the [fuse box] of the clip to burn out, please pay attention to the operation method.

The product has just been received. You need to first turn on the flashlight to discharge it, and then charge the product for more than 4 hours before starting the car, as there is virtual electricity inside the product This operation can extend the service life of the product!
1. It is recommended to start the vehicle with a three grid power supply or at least 60% power supply
2. Check if the pile head of the battery is clean
3. Ordinary clamp start: Check whether the blue port of the clamp is fully inserted, whether the clamp contacts the positive and negative electrodes of the battery with the maximum area, and whether the clamp is stable and does not shake First, clamp the positive and negative poles of the clamp onto the positive and negative poles of the battery, and wait for 2 to 3 minutes before starting the car. This operation can reduce the load on the power supply

Features:

*1. The product adopts high-light technology, small size, easy to carry, lightweight and large capacity.

*2. Universal for multiple models, 12V car emergency boot, high-rate battery easy start.

*3. With a USB output port, it can charge mobile phones, MP3 and other devices.

*4. Equipped with an LED flashlight for emergencies.

*5. The high-performance polymer lithium battery cell resists temperature from -20°C to 60°C to ensure that the battery stops and starts normally. The thickened and thick battery clip is safe and does not hurt the car.

Description:

*1. Material: ABS

*2. Size: Approx.13.9×7.8×2.4cm/5.47×3.07×0.94inches

*3. Starting current: 600A

*4. Input Interface: USB-C

*5. LED Light: yes

*6. Socket Type: USB

*7. Input: 5V/1A

*8. Output: 5V/2A, 12V

*9. Working Temperature: -20℃~+60℃

*10. Applicable Models: 12V gasoline vehicles

Package Includes:

1 x Car Jump Starter